Low Base Wide Ride Seat

For this install, we removed a “very used” stock-factory type seat.

We are installing a low-base / wide-ride ultra leather seat by Bostrom (shown here with base fully inflated)

Seen here: Low-Base seat (left) fully inflated is still a little lower than factory seat (right) completely deflated

Shown here: Both seats completely deflated

Approximate height of deflated low-base seat – 11 inches – floor board to seat cushion

Cut a cardboard or paper template the exact size of the bottom base of your new low-base seat. Then place in your truck as shown – mark & punch all four holes.

Take pattern, overlay on new seat base, line up 2 front holes on template “in-line” with factory drilled holes on seat base

Once template is firmly in position, mark holes with magic marker and center punch. Then drill marked holes with 7/16 drill bit.

Set seat into position – start from 2 bolts, then connect air line and inflate seat so you can access rear bolts more easily. Tighten all bolts.

You will need to locate (2) 7/16 fine thread nuts to secure factory seat belts to your Bostrom seat – you can re-use factory bolts.

Now you can “ride low” & “cruise slow” like the Cowboyz – Baby!

Order from our complete inventory of Bostrom “Wide-Ride” seats at: 4StateTrucks.com

Most styles cost $649 - $699